0.96 Inch OLED Display Module SSD1306 I2C IIC SPI Serial 128X64 LCD 4 Pin YellowBlue WhiteBlue for Arduino
It works without backlight, that is, in a dark environment OLED display is higher compared to that of LCD display you will like the miniature for its crispness.
The Driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.
That is, except the VCC and GND, 2 wires would be needed when using 4-wires I2C mode.
There is also a simple switch-cap charge pump that turns 5v into a low voltage drive for the OLEDs, making this module the easiest ways to get an OLED into your project.
LILYGO® TTGO T8 ESP32-S2 V1.1 ESP32-S2-WOOR Development Board WIFI Wireless Module Type-C Connector TF Card Slot 4MB FLASH BOOT
Introduction For easy prototyping and interfacing, choose development boards from our ESP32-S2 Series. Use our all-in-one dev boards to create your own IoT applications quickly and hassle-free.
- MCP2515 CAN Bus Module TJA1050 receiver SPI For 51 For arduino Diy Kit MCU ARM controller
PCB Double Side Copper Clad Plate DIY PCB Kit Laminate Circuit Board
- 3D PRINTERS
- CNC & DIY
- DEVELOPMENT PLATFORMS
- IOT TOOLS
- PROJECTS & EDUCATION
- ROBOTCS & DRONES
- TOOLS & ACCESSORIES