Name: Square Heatbed Magnetic Sticker
1.The product is divided into two sides of the A.B board.
A side:High temperature print layer B side:Low temperature adhesive layer
2.Separate bending to take the model. It is more convenient.
3.No need for beautiful paper and scrapers to assist the model.
4.Can be installed on hot bed and glass platform.
5.Printing does not warp. No glue is needed.
6.Can be printed on a cold bed.
7.The A plate is flexible and magnetic, easy to move away from the build platform, take away the print model
8.Ours is PC material, short-term temperature resistance of 180 degrees, long-term 130 degrees. More than 130 degrees of magnetic properties will be weakened but will not lose magnetism, so can be applied to PLA/ABS and other filament.
9.PC material is flame retardant and wear resistant. Oxidation resistance, low mold shrinkage, good dimensional stability
10.A B board is flat，It can better reduce printing errors and make the printed model more standard
The temperature of the magnetic sticker on the market cannot exceed 80 degrees. If it exceeds 80 degrees, it will lose its magnetic properties, but our products can reach 130 degrees without losing magnetism. Can be applied to a variety of consumables such as PLA / ABS printing.
PLA: hot bed temperature 50~80 degree.
ABS: the temperature of the hot bed is 100 degrees.
1. Before sticking the b surface, be sure to wipe the surface of the hot-bed platform clean, otherwise air bubbles will be easily generated during use! !!
2. In order to effectively reach a good non-warped state, it is recommended that the temperature of the hot bed should not exceed 80 degrees.
3 Before printing, please keep the platform leveling nozzle and the platform within 0.05mm, about one sheet of paper is the best thickness. After printing, please remove the model in time. If the cooling time is too long, the model’s platform adsorption will be larger.
4.Please do not let heated nozzle touch the A plate directly !
5.Due to the magnetic pole factor, the magnetic poles are directional when the two stickers are attracted.If the suction is unstable, please rotate side A by 90 degrees.
Due to the magnetic pole factor, the magnetic poles are directional when the two stickers are attracted.If the suction is unstable, please rotate side A by 90 degrees.
After finding the strongest and most suitable magnetic position, tear open the B-side adhesive, directly attach it to the platform, Be careful to flatten it, and adsorb the A-side printing layer on the B surface without bubbles.