ARDUINO ACCESSOIRES
1.100,00 د.ج900,00 د.جIt works without backlight, that is, in a dark environment OLED display is higher compared to that of LCD display you will like the miniature for its crispness.
The Driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.
That is, except the VCC and GND, 2 wires would be needed when using 4-wires I2C mode.
There is also a simple switch-cap charge pump that turns 5v into a low voltage drive for the OLEDs, making this module the easiest ways to get an OLED into your project.
1.100,00 د.ج900,00 د.جIt works without backlight, that is, in a dark environment OLED display is higher compared to that of LCD display you will like the miniature for its crispness.
The Driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.
That is, except the VCC and GND, 2 wires would be needed when using 4-wires I2C mode.
There is also a simple switch-cap charge pump that turns 5v into a low voltage drive for the OLEDs, making this module the easiest ways to get an OLED into your project.
800,00 د.ج500,00 د.ج- Environmentally friendly materials, degradable.
- There are many styles and models, and there are different models for different needs.
150,00 د.ج- Length: 100 mm
- Weight: 30~35 gm each
- 1p-1p pin header
- Compatible with 2.54mm spacing pin headers
- 10pcs chromatic color jump wire
- High quality and in good working condition
- Durable and reusable
- Easy to install and use
- A popular choice for construction or repair
- Be used for the electronic project and Genuine Arduino product
- Flexible Breadboard Jumper Cable Wire allows you plug and unplug easily for prototyping.
- Breadboard connections which allow you plug and unplug easily for prototyping and can be used over and over again.
60,00 د.ج- 10Pcs/Lot 3MM Ultra Bright Emitting Diode Dides Round Water Clear Green/Yellow/Blue/White/Red LED Light
250,00 د.ج- Length: 200 mm
- Weight: 30~35 gm each
- 1p-1p pin header
- Compatible with 2.54mm spacing pin headers
- 10pcs chromatic color jump wire
- High quality and in good working condition
- Durable and reusable
- Easy to install and use
- A popular choice for construction or repair
- Be used for the electronic project and Genuine Arduino product
- Flexible Breadboard Jumper Cable Wire allows you plug and unplug easily for prototyping.
- Breadboard connections which allow you plug and unplug easily for prototyping and can be used over and over again.
800,00 د.ج450,00 د.ج- Une carte adaptateur d’extension GPIO rouge(Ne comprend pas la planche à barbe 400 Points)Câble ruban plat 26 broches 2.54-picth 200mm
120,00 د.ج- 5v Active Buzzer Magnetic Long Continous Beep Tone 12*9.5mm
1.600,00 د.ج1.500,00 د.جMini Small Size Electromagnetic Electric Control Cabinet Drawer Lock Two Options: DC5V-6V or DC 12V
3.000,00 د.ج- SPI Flash – Default 32Mbit
- RAM – 520KB SRAM + 4MB PSRAM
- Bluetooth – Bluetooth 4.2 BR/EDR and BLE standards
- Wi-Fi – 802.11 b/g/n/
- UART Baudrate – 115200 bps
- Image Output Format – JPEG( OV2640 support only ), BMP, GRAYSCALE
- Spectrum Range – 2412 ~2484 MHz
- External Storage: micro SD card slot up to 4GB.
- Camera
- FPC connector.
- Support for OV2640 (sold with a board) or OV7670 cameras.
- Image Format: JPEG( OV2640 support only ), BMP, grayscale.
- LED flashlight.
- Expansion: 16x through-holes with UART, SPI, I2C, PWM.
- Misc: Reset button.
- Power Supply: 5V via pin header.
- Power Consumption.
- Flash LED off: 180mA @ 5V.
- Flash LED on to maximum brightness: 310mA @ 5V.
- Deep-sleep: 6mA @ 5V min.
- Modem-sleep: 20mA @ 5V min.
- Light-sleep: 6.7mA @ 5V min.
- Dimensions (ESP32): 40 x 27 x 12 (LxWxH) mm.
- Temperature Range: Operating: -20 ℃ ~ 85 ℃; storage: -40 ℃ ~ 90 ℃ @ < 90%RH.
1.200,00 د.جFour Road 4 Channel Infrared Detector Tracking Transmission Line Obstacle Avoidance Sensor Module for Arduino Diy Car Robot
900,00 د.ج800,00 د.ج- GY-521 MPU-6050 MPU6050 Module 3 Axis Analog Gyro Sensors+ 3 Axis Accelerometer Module For Arduino
1.400,00 د.ج- Less noise, light weight.
- Used for model airplane accessories.
- Stable performance and shock proof.
- Used for all remote control applications mainly R/C cars boats planes and as tail servos for helicopter.
450,00 د.ج350,00 د.جSmart Electronics New for Arduino Diy Smart Car Robot Reflective Photoelectric 3pin IR Infrared Obstacle Avoidance Sensor Module
160,00 د.ج- Battery type: Zinc Carbon battery
- Dimension: 26.5mm x 48.5mm x 17.5mm
- Nominal voltage: 9V
- Cut-off voltage: 5.4V
- Discharge Resistance(Ω): 620
- Capacity : 600 mAh