SALE-6%
Roll over image to zoom in
Color | Blue, Green |
---|
Based on 0 reviews
0.00
Overall
|
|
0% |
|
|
0% |
|
|
0% |
|
|
0% |
|
|
0% |
Be the first to review “DC 5V-6V/DC 12V Mini Small Size Solenoid Electromagnetic Electric Control Cabinet Drawer Lock” Cancel reply
SKU: INO-S-043
Categories: ARDUINO, ARDUINO ACCESSOIRES, ARDUINO SENSORS, ARDUINO SHIELDS, DEVELOPMENT PLATFORMS, RASPBERRY PI, RASPBERRY PI SENSORS, RASPBERRY PI SHIELDS
Tags: arduino, Control, Electric, Electromagnetic, mini, Module, Size, Small, Solenoid
- Motor power supply is 3V~6V.
- All the parameter above is tested without load
- Please notice that the wooden outside is just a PROTECTION FILM. You need to TEAR OFF the yellow-brown protective paper outside the car chassis, and you will see the transparent clear car chassis inside.
- Please allow 1-2cm errors due to manual measurement
- Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same
- Very handy and simple in assembling/disassembling.
- Strong components so as to withstand extreme terrain conditions.
- Transparent Car Chassis.
- Attractive design.
- Double layer structure, much of mounting holes, enough space
1.200,00 د.ج
- Red LED checks the state of the proximity sensor
- High repeated positioning accuracy
- High switching frequency
- Wide voltage range
- Total Length of cylinder: 62mm.
- Thread length: 40mm.
- Outer (Theard) Diameter: M12
- Antivibration, dust, water and oil prevention
- Reverse power protection, short circuit protection, directly connecting with PLC
- Can replace small switches and limit switches
17.800,00 د.ج
- Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.4GHz
- 1GB LPDDR2 SDRAM
- 2.4GHz and 5GHz IEEE 802.11.b/g/n/ac wireless LAN, Bluetooth 4.2, BLE
- Gigabit Ethernet over USB 2.0 (maximum throughput of 300 Mbps)
- Extended 40-pin GPIO header
- Full-size HDMI
- 4 USB 2.0 ports
- CSI camera port for connecting a Raspberry Pi camera
- DSI display port for connecting a Raspberry Pi touchscreen display
- 4-pole stereo output and composite video port
- Micro SD port for loading your operating system and storing data
- 5V/2.5A DC power input
- Power-over-Ethernet (PoE) support (requires separate PoE HAT)
- 11 b/g/n Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Use CH340G replace the CP2102.
- Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
- Arduino-like hardware IO
- Integrated low power 32-bit CPU
- Advanced API for hardware IO, which can dramatically reduce the redundant work for configuring and manipulating hardware.
- Code like Arduino, but interactively in Lua script.
- Nodejs style network API
- ATmega328 running at 16MHz with external resonator (0.5% tolerance)
- 0.8mm Thin PCB
- USB connection off board
- Supports auto-reset
- 5V regulator
- Max 150mA output
- Over-current protected
- Weighs less than 2 grams!
- DC input 5V up to 12V
- Onboard Power and Status LEDs
- Support serial download
- DIY project prototyping.
- Developing varied varieties of projects that require a code based control.
- Automation System development.
- Learning AVR programming.
- Entry level circuit designing.
800,00 د.ج
- Set of 3 aluminum heat sinks
- Suitable for Raspberry Pi B+, Pi 2 B, Pi 3B, Pi 4B. Preferably use with Raspberry Pi 4 Model B
- These heat sinks have profiles that are short enough to fit within standard Raspberry Pi cases.
- Material: aluminum
- Color: Black
- Digital Output
- Single Wire Output
- Stable & long term accuracy
- Full range temperature compensated
- Relative humidity and temperature measurement
- Calibrated digital signal
- Outstanding long-term stability
- pins packaged and fully interchangeable
- Low power consumption
- 4 pins package
- Compatible with Arduino NANO
- All digital and analog pins breakout
- Compact size;
- Leads all pins out, convenient for wiring and doing experiments.
- Compact size (24 x 32 mm)
- Infrared sensor: dual element, low noise, high sensitivity
- Light sensor: CdS photocell (can be add as customer requirement
- Infrared Sensor with Control Circuit Board
- The Sensitivity and Holding Time Can be Adjusted
- Blockade time: 2.5s (Default)
- Sensitive Setting: Turn to Right, Distance Increases (About 7M); Turn to Left, Distance Reduce (About 3M)
- Time Setting: Turn to Right, Time Increases (About 200S); Turn to Left, Time Reduce (About 5S).
- ATmega16U2 instead 8U2 as USB to serial converter
- 1.0 pinout
- Stronger RESET circuit
- 5V operating voltage
- Input voltage (recommended) range from 7V to 12V
- Input voltage (limit) range from 6V to 20V
- 40mA DC current per I/O pin
- 256KB flash memory of which 8KB used by bootloader
- 8KB SRAM
- 4KB EEPROM
850,00 د.ج – 1.200,00 د.ج
- 16 characters wide, 2 rows
- Blue/Green Backlight
- 5×7 Dot Matrix Character + Cursor
- HD44780 Equivalent LCD Controller/driver Built-In
- 4-bit or 8-bit MPU Interface
- Works with almost any Microcontroller
- Can be fully controlled with only 6 digital lines! (Any analog/digital pins can be used)
- Integrated MF RC522
- 13.56MHz contactless communication card chip.
- Low-voltage, low-cost, small size of the non-contact card chip to read and write.
- Suitable for Smart meters and portable handheld devices.
- Advanced modulation and demodulation concept completely integrated in all types of 13.56MHz passive contactless communication methods and protocols.
- 14443A compatible transponder signals.
- ISO14443A frames and error detection.
- Supports rapid CRYPTO1 encryption algorithm, terminology validation MIFARE products.
- MFRC522 support MIFARE series of high-speed non-contact communication, two-way data transmission rate up to 424kbit/s.
- Low cost, and ideal for user equipment development.
- The reader and RF card terminal design meets advanced applications development and production needs.
- Can be directly loaded into the various reader molds, very convenient.
- Supported card types: mifare1 S50, mifare1 S70 MIFARE Ultralight, mifare Pro, MIFARE DESFire
950,00 د.ج – 1.050,00 د.ج
- High resolution
- Accurate positioning
- Fast control response
- Constant torque throughout the servo travel range
- Excellent holding power
Reviews
There are no reviews yet.